 |
|
 |
New Jersey
home inspection NJ home
inspectors perform
Certified New Jersey home
inspections in NJ.
SAGGING RAFTER / RIDGE / BEAM
/ JOIST OR FRAMING MEMBERS:
Sags in buildings are unsightly as well as
potentially unsafe. In today's construction
building codes are provided as a guideline for
the builder to help construct safer more durable
structures without undue waste of raw materials.
Building codes are founded on broad-based
performance principles and are necessarily
provided as a minimum standard in most cases.
Often this will happen after a
new roof has been installed which is heavier
than the rafters were intended for or a new roof
may have been installed over an old roof adding
excessive weight to the rafters. Another reason
the inspector will check this item is when it is
noted that certain framing members are not
properly sized, spaced, or spanned, as per
building standards, or are not safely installed
with sufficient fasteners, etc.
Some framing
member sags are actually framing member warpage
and not caused by overloading. This problem must
be carefully studied to be sure this, in fact,
is the situation. Sometimes under the building
it is noted that the supporting posts or piers
are not properly spaced or are missing allowing
sag of floor girders and joists.
Mild sagging is
usually ignored by the property owner. More
serious situations may cause walls to push out
of plumb, etc. Sags in flat roofs may cause
water to pool thereby damaging the roofing
material prematurely. Adding supports, such as
"purlins," to attic framing members is
usually quite easy.
It is important that
supports be installed atop bearing walls only,
or the sag may transfer down through the wall
and cause the floor to sag. A bearing wall is
one that is sitting atop a foundation, a row of
piers or a grade beam. Floor joist and other
floor framing members are also quite easy to
brace. The purlin must be "kicked off"
to bearing walls up but often require jacking
the member up which can cause cracks to siding
and interior walls. ,br>Often this type repair is
done just before repainting. Floor sag repairs
usually require placement of extra piers
underneath the joists or beams. Piers are
available which are adjustable and these
sometimes eliminate the need for jacks. Second
story floor sags are often more difficult to
remedy since it may require placement of a beam
and/or post in living quarters below. Repair
techniques are so varied that it may be
necessary to contact the inspector for
additional information if you intend to do it
yourself, or with the assistance of a
knowledgeable helper, otherwise we recommend you
call on the services of a General Building
Contractor.
The above information was provided by TWI Systems Copyright 1995-2005 1-800-553-5660 |
|
|
|

File last updated May 22, 2012 * Copyright © 2012 All rights reserved by: Accurate Inspections, Inc. A New Jersey home inspection firm 56 Woodland Drive, Woodland Park (formerly West Paterson) NJ 07424 973-812-5100 providing New Jersey Certified Home Inspections in NJ, by New Jersey Licensed home inspectors. Inspector of record Michael Del Greco, New Jersey Home Inspector License GI 0121.
Paterson NJ, Clifton NJ, Passaic NJ, Wayne NJ, Parsippany-Troy Hills NJ, Bloomfield NJ, Hackensack NJ, West Orange NJ, Teaneck NJ, Montclair NJ, Kearny NJ, Fort Lee NJ, Belleville NJ, Fair Lawn NJ, Westfield NJ, Englewood NJ, Garfield NJ, West Milford NJ, Livingston NJ, Nutley NJ, Paramus NJ, Bergenfield NJ, Ridgewood NJ, Lodi NJ, Lyndhurst NJ
NJ Real Estate Lawyer -
New Jersey Mold Test -
Home Inspection Checklist -
Home Inspection Horror Stories -
New Home Inspection Checklist - Contact Us -
How to become a home inspector -
Home-Inspection-Video -
NJ-Home-Inspections -
Home Inspection Business -
home inspection reviews
New Jersey Home
Inspection
Del Greco
|
|